1800 816 277
www.tti.com.au
20
FloodRite
™
Product HandBook
•
At the rear of the unit (pipework and pump end), slide the rear legs into the box cross-section of the
frame. With the legs fully extended, lock with the pins provided.
NOTE! Ensure that there is an observer to direct the driver when
manoeuvring the tipper tray to load the FloodRite™ unit.
•
Using an observer, carefully reverse the tipper to the front of the FloodRite™ unit, ensuring it aligns
accurately with the centre of the tipper tray.
•
Carefully raise the tipper tray slightly such that the small wheels mounted at the front of the FloodRite™
frame are just above the tipper tray. Slowly start reversing the tipper under the unit.
•
Carefully keep reversing the tipper until the tipper tray reaches the pair of front legs. Lower the tipper
tray slightly (which will raise the back edge of it) until the weight of the front of the FloodRite™ unit rests
on the tipper tray floor.
•
Remove the pin from the top of the front legs, then swing each leg up into the slot on the main frame and
lock with the pins.
•
Continue reversing while gradually lowering the tipper tray. The tipper tray should still be raised
sufficiently such that the FloodRite’s front wheels can roll along the tray floor. Stop the vehicle when
the the unit reaches the tipper’s hoist well or reaches the rear legs, depending on the tipper tray length.
Lower the tipper tray completely, which will lift the rear legs off the ground.
•
Remove the the pin on each of the rear legs. Slide the lower leg section up into the upper section until
the lowest hole is reached, then re-insert the pin.
•
Secure the FloodRite™ to the floor of the tipper tray. If using airlocks, bolt 50mm x 50mm angle
underneath the unit using the pre-drilled holes.