Installing SNMP Management Board in 16-Port 10BaseT Hub
The SNMP Management circuit board attaches to the 96-pin connector
located on the 16-Port 10BaseT circuit board inside the 16-Port 10BaseT
hub.
WARNING: DISCONNECT POWER CORD from 16-Port 10BaseT hub
before installing the SNMP Management Board. Failure to observe this
warning could result in personal injury or death from electrical shock.
WARNING: AVOID CONTACT WITH POWER SUPPLY during board
installation. Failure to observe this warning could result in personal
injury from electrical shock caused by capacitive discharge.
CAUTION: Wear a grounding device and observe electrostatic discharge
precautions when installing the SNMP Management board. Failure to
observe this caution could result in circuit board failure.
Tools:
Medium Phillips screwdriver
Small standard screwdriver
3/16-inch nut-driver
1.
Place 16-Port 10BaseT hub on table or other stable surface.
2.
Using medium Phillips screwdriver, remove four (4) screws
that secure the cover to the 16-Port 10BaseT hub left side and
four (4) screws that secure the cover to the 16-Port 10BaseT
hub right side.
3.
Using Phillips screwdriver, remove one (1) screw that secures
cover to 16-Port 10BaseT hub back.
4.
Using 3/16-inch nut driver, remove four (4) hex nuts that
secure the cover to the Cascade Connectors and two (2) hex
nuts that secure the cover to the serial port connector.
5. MAINTENANCE
5-13
MANAGEABLE HUB
4
5
3
2
2
4