3.2.2
Table-Top Installation
NOTE: StackMaster™ Units are shipped with a separate, unattached set of
adhesive-backed rubber feet.
CAUTION: The rubber feet MUST BE INSTALLED on the StackMaster™
Unit if a StackMaster™ Unit is installed on a table-top or other flat
surface. Failure to observe this caution could cause the StackMaster™
Unit to overheat and could result in data transmission failure and/or
equipment damage.
CAUTION: If the StackMaster™ Stack will include an SNMP
Management Unit or a StackMaster™ Unit with an SNMP Management
Board, the SNMP Management Unit or the StackMaster™ Unit with the
SNMP Management Board must be installed at the top of the stack.
Failure to observe this caution will invalidate the SNMP network
management.
To install the StackMaster™ Stack on table or other flat surface:
1.
Determine StackMaster™ Unit to be installed at bottom of stack.
2.
Carefully turn StackMaster™ Unit to side and install four (4)
rubber feet:
•
Remove protective paper from adhesive surface of rubber
foot.
•
Position rubber foot at bottom corner of Stackmaster Unit
•
Secure rubber foot to StackMaster™ Unit.
•
Repeat for remaining rubber feet.
3.
Return StackMaster™ Unit to upright position.
4.
Repeat step 2 for next StackMaster™ Unit to be installed.
5.
Carefully set StackMaster™ Unit on StackMaster™ Unit previously
installed.
6.
Continue steps 4 and 5 until all StackMaster™ Units have been
installed.
NOTE: The mounting brackets that come installed on the StackMaster™
Unit can be removed and saved for later use.
3. INSTALLATION
3-5
MANAGEABLE HUB