4
CONFIGURATION
OVERVIEW
The indicator contains two main configuration menus:
The Setup (“F”) menu, which configures the indicator to your weigh platform
The User (“A”) menu, which configures the serial communication port and enables some user
options
The Setup and User menus consist of several menu selections, each with its own sub-menu of selections
or programming procedures. To configure the indicator you must first enter the appropriate menu mode.
Once there, four of the front panel keys become directional navigators to move around in the menus, and
one key is used to save or SET the selections.
ACCESSING THE MENUS
To access the Setup (“F) menu:
1.
Power off the indicator.
2.
Press and hold the “SET” key for about three seconds while turning the unit back on. The display
shows ” F 1” to indicate that you are in Setup Menu mode.
3.
Use the navigation keys shown in the Figure 10 to move through the menu.
To access the User (“A) menu:
1.
Enter the Setup (“F”) menu.
2.
Use the right or left directional keys shown below to move right or left in the Setup (“F”) menu until
the indicator shows ” A 1”.
SETUP MODE KEY FUNCTIONS
ZERO
GROSS
NET
TARE
SET
UNITS
MENU STRUCTURE
All menus consist of a top level (heading) and a secondary level. The top level contains the code (e.g. F1)
for the parameter to be configured. The secondary level contains the selection list or allows access to a
programming sequence.
Use the directional keys to move around in the Menu Structure shown below.
F1
Grads
10
80
F2
Sampling
Numeric Entry
Etc.
