TransAct RESPONDER MP2, Quick Start Manual

Page: 31 / 39

100-13809 - Rev B
Page - 23 -
Mounting and Assembly Instructions
This section discusses instructions for mounting of the Quick Release Plate
and assembly of the optional battery pack.
Installing Quick Release Plate
The Responder MP2
TM
printer can be optionally mounted to a Quick Release
Plate for easy installation and removal in vehicle and other applications.
The Quick Release Plate is a fixed plate attached to the surface of a vehicle or
other location, allowing the printer to quickly be attached or removed from its
fixed location.
The printer slides on or off the Quick Release Plate at four attachment points
using wall mount studs screwed in to corresponding mounting holes in the
back of the printer, as shown in the figures below. A latch arm at the bottom of
the wall mount bracket locks and unlocks the printer into place.
Note: The wall mount studs are installed in place of default rubber feet
installed on the base of the printer, as shown in the image below, using the
same mounting holes.
To install the Quick Release Plate, drill holes for five M3 attachment screws in
the mounting surface of the vehicle or other location, using the Quick Release
Wall mount
studs
Latch arm