TransAct RESPONDER MP2, Quick Start Manual

Page: 14 / 39

100-13809 - Rev B
Page - 6 -
Important Safety Precautions
General Precautions

Never place the printer on a slanted or unstable location. If the printer is
dropped or slides off, this could cause personal injury.

Place the printer in a location that meets the specified ranges of
temperature and humidity. If the printer is either too cold or too hot, it may
not operate normally. Operating environment: -10ºC to +50°C (14°F to
122°F).
Supply Voltage:
DC 12-28 V, 5 amps maximum while printing, 20 mA maximum standby
Handling the Printer and Accessories

Never clean the printer with water or any flammable liquid (benzene,
thinner, etc.) either applied directly or with a cloth. If you accidentally spill
liquid on the printer, switch the printer off immediately, disconnect the
power plug from the power source, and call for service.

If the printer emits smoke, unusual odors, or makes noises, leaving it could
cause a fire or damage to the printer. Switch the printer off immediately,
disconnect the power plug from the power source, make sure that the
printer has stopped smoking, and call for service. Do not attempt to repair
the printer by yourself.

Use only a slightly damp cloth, thoroughly wrung out, to clean the printer
surfaces. Never use alcohol, thinner or any other flammable liquids, or risk
having them come into contact with electrical components inside the
printer.

Never insert or drop any metal objects into the printer when it is open. This
could cause a fire or damage the printer. If something falls into the printer
accidentally, switch the printer off immediately, disconnect the power plug
from the power source and call for service.

If the printer is dropped and damaged, switch the printer off immediately,
disconnect the power plug from the power source, and call for service.

Never use flammable sprays around the printer.

Never remove the cover from the printer.

Before cleaning the printer, switch it off and disconnect the power plug
from the power source.
Note:

Do not rapidly switch the printer off and on. This could damage the printer.
After switching the printer off, wait at least 5 seconds before switching it on
again.