TransAct RESPONDER MP2, Quick Start Manual

Page: 32 / 39

100-13809 - Rev B
Page - 24 -
Plate as a template for the hole locations as shown. The dimensions of the
pattern are outlined in the figure below.
Attach the Quick Release Plate to the mounting surface using these screws,
remove the rubber feet from the printer by unscrewing the Philips screws
holding them in place, fasten the wall mount studs to these same mounting
hole locations on the printer, and slide the printer into place onto the Quick
Release Plate.
Mounting holes
for wall mount
studs
Default rubber
feet