23
UNT-SVX16I-XX
SÄHKÖKYTKENNÄT
Sähköasennukset tulee suorittaa
kyseisen maan lain ja säädösten
mukaisesti.
Kytkentäkaaviot
eivät
käsittele
suojaavia maadoituksia
tai muita
sähköisiä turvamekanismeja, jotka
vaaditana paikallisten säädösten,
säännösten, määräysten, koodien ja
standardien mukaan tai paikallisen
sähköntoimittajan vaatimuksesta.
Ennen yksikön asentamista varmista,
että virtalähteen jännite on 230V - 50
Hz.
Virtalähde on aina kytketty piirin
liittimiin L, N ja PE.
Maksimi virrankulutus 230
VAC päävirtalähteelle on:
Varmista sulakkeiden riittävyys sekä
puhallinyksikölle
että
muille
tarvittaville kodinkoneille ja laitteille.
ELECTRICAL
CONNECTIONS
Perform electrical connections in
accordance with laws and regulations
in force in the country concerned.
The wiring diagrams do not address
protective grounding or other electrical
protection which will be required under
local rules, regulations, codes and
standards or by the local electricity
supplier.
Before installing the fan coil, make
sure the rated voltage of the power
supply is 230V - 50 Hz.
The power supply is always connected
to terminals L, N and PE on the
board.
Maximum power consumption for
230 VAC mains power operation is
as follows:
Make sure that, in addition to supplying
the working current required by the
fan coil, the mains electrical supply
is also able to supply the current
necessary to operate other house-
hold appliances and units.
If using the CWE Cassette
fan coils with electronic
controllers, the voltage
values at the autotransformer
terminals must be kept in
consideration (transformer return
voltages). These values may reach
500 Vac.
Upstream of the unit, a disconnection
switch must be provide and shall have
a contact separation in all poles,
providing full disconnection under
overvoltage category III condition.
The unit must always be earthed.
Always disconnect the electrical power
supply before opening the unit.
The minimum cross section of the
electric wires is 0.75 mm
2
M
ALLI
CWe 1
CWe 2
CWe 3
CWe 4
CWe 5
28,5
44,0
81,0
43,5
126,0
0,25
0,40
0,70
0,40
1,10
KOKONAISTEHO
W
A
M
odel
CWe 1
CWe 2
CWe 3
CWe 4
CWe 5
28,5
44,0
81,0
43,5
126,0
0,25
0,40
0,70
0,40
1,10
t
otAl
A
bsorbtion
W
A
Jos
CWE
kasetti
puhallinpatteria käytetään
elektronisilla ohjaimilla,
tulee automaattimuuntimen
kennojen
j
ännitteen
arvot ottaa huomioon (muuntimen
paluujännite).
Arvot voivat olla
500 Vac.
Virrankatkaisukytkin tulee olla yksikön
vastavirtaa
varten
ja
kytkentäerotin
tulisi olla
jokaisessa
navassa,
varmistamassa
täydellisen
poiskytkennän
Y
lijännite kategorian III mukaan.
Yksikön tulee aina olla maadoitettu.
Kytke aina virtalähde pois päältä
ennen yksikön avaamista.
Sähköjohtojen minimihalkaisija
on 0
.75 mm
2
Summary of Contents for UNT-SVX16I-XX
Page 78: ...UNT SVX16I XX MUISTIINPANOT...
Page 79: ...UNT SVX16I XX MUISTIINPANOT...