Trane 2MCC05-C, Installation Manual

Page: 15 / 80

MS-SVN056C-EN 15
Cassette Unit Installation
3. Panel placement
• Align panel’s swing motor with the refrigerant connections on the body of the unit.
• Insert panel hooks into the swing motor and the opposite sides to the hooks of the
corresponding water deposit. Hang the other two panel hooks to the corresponding sections
on the body of the unit.
Note: Do not entangle the swing motor cable inside the insulation sponge material.
• Adjust all four panel hanging rods to horizontal position; adjust them equally until they reach
the ceiling.
• Place the panel following the arrows in order to center it to the opening on the ceiling. Make
sure that all four corner hooks are adjusted correctly.
• Tighten the screws below the panel hooks until the width of the sponge between the body
and panel outlet is reduced to approximately 4 to 6 mm. The edge of the panel must touch
the ceiling. Failure in the operation of the unit may be due to inappropriate adjustment of
the panel screw.
• If after adjustment of the installation screws a spacing can be observed between the panel
and the ceiling, the height of the indoor unit must be modified once more.
• Modification of the unit’s height can be done through the openings at the four corners of the
panel, provided that the adjustment of the indoor unit and the drain pipe will not be affected.
4. Install the air grill inside the panel. Connect power leads to the swing motor and control box
at their corresponding terminals.
5. Reinstall the air grille inverting the procedure employed to dismount it.
6. Reinstall the corner covers on the panel.
• Connect the panel cable to the screw on same panel.
• Carefully press the corner cover inside the panel.
Piping connection
water drain
Support anchor
Swing motor
Hook
screw
Refrigeration connection
(líquid and suction
)
Water deposit (internal)
Phillips screwdriver