Trane 2MCC05-C, Installation Manual

Page: 47 / 80

MS-SVN056C-EN 47
Wired Controller
Installation procedure
Wiring technique:
Installation instructions
To use the remote control unit, install a 5-wire terminal block and adhere an infrarred emitter close
to the switch receiver. Connect anode and cathode to A, B on the terminal board; c5V, GND,
RUN coming from the switch independently from C, D, E of the 5-wire terminal block.
This board accepts 5-wire cable which length
should match actual conditions.
Wired
Remote Control
Terminal board
Terminal block protrudes from the
back cover; a perforation is required
to allow for correct mounting.
It must not be connected directly
to the wall!
To join the front cover to
the back side of the remote
control, latch the first lug
and then latch the other.
Wooden
screw (M4X20)
Control panel
cover
Control panel
LCD screen
Remote control
front cover
Remote control
back cover
To separate both parts pry borders
using the tip of a screwdriver
Remote control
Mounting screws B
ST2.9x10-C-H
CANCEL LOCK
SET TEMPERATURE(°C)
AUTO
COOL
DRY
HEAT FAN
HIGH
MED
LOW
TEMP
MODE
SWING TIMER
RESET
ON/OFF
FAN
SPEED
VENT
ECONOMIC
RUNNING