TracVision M5/M7 User’s Guide
51
Chapter 3 - Settings
Switching Between Installed Satellites Using a PC
Follow the instructions below if you wish to use a PC to switch
between your installed satellites.
NOTE: Linear versions with receivers synchronized for use with the
TracVision system will need to restart the antenna after performing this
procedure to resume receiver-controlled satellite switching.
1. Connect a PC to the maintenance port, as described in
“Connecting a PC to the Maintenance Port” on page 27.
Then type the following commands in the
HyperTerminal window.
2. Type the appropriate command below to switch to your
desired satellite then press Enter.
*DISH 1000 and European Tri-Sat setups only.
TIP: To determine which satellites are installed, and in which
satellite position (A, B, or C), refer to “Determining Which Satellites
are Configured for Tracking” on page 36.
To Switch To
Type
Satellite A
@L,A
Satellite B
@L,B
Satellite C*
@L,C