TracVision M5/M7 User’s Guide
39
Chapter 3 - Settings
Configure the Receiver(s)
NOTE: If you are connecting multiple receivers, repeat this process for each
additional receiver. You will need to connect each receiver, one at a time, to
the RF1 cable and perform the steps below. Then, once you have completed
this process for each receiver, you can reconnect them as desired.
1. Dock the vessel in a blockage-free area.
2. Ensure the receiver you wish to configure is connected
to the TracVision system’s RF1 cable.
3. Turn on the TV and receiver.
4. Set the switchplate’s power switch to the On (|)
position to apply power to the TracVision antenna.
Wait one minute for system startup.
Figure 3-11 Switchplate Power Switch
5. Using the receiver’s remote, go to the “Point Dish/
Signal Strength” screen (press MENU, 6, 1, 1 on most
models).
6. Choose Check Switch, then press SELECT.
7. Choose Test, then press SELECT.
8. Wait at least 15 minutes before proceeding. Disregard
messages on the TV stating the test is complete; you
must wait 15 minutes before proceeding.
MAINTENANCE
OFF
ON
Please be patient. The Check Switch test takes approximately 15
minutes to complete. Disregard any messages on the TV stating
the test is complete; the antenna must perform additional
operations before proceeding.
IMPORTANT!
