TracVision M5/M7 User’s Guide
41
Chapter 3 - Settings
3. Type
SATINSTALL,TRISAT,DISH61
then press
Enter.
4. Enter the vessel’s latitude and longitude into the
antenna using the
GPS
command, as explained in
“Setting Latitude and Longitude” on page 30.
5. Type
ZAP
then press Enter to restart the antenna. Wait
one minute for system startup.
Configure the Receiver(s)
NOTE: If you are connecting multiple receivers, repeat this process for each
additional receiver. You will need to connect each receiver, one at a time, to
the RF1 cable and perform the steps below. Then, once you have completed
this process for each receiver, you can reconnect them as desired.
1. Dock the vessel in a blockage-free area.
2. Ensure the receiver you wish to configure is connected
to the TracVision system’s RF1 cable.
3. Turn on the TV and receiver.
4. Set the switchplate’s power switch to the On (|)
position to apply power to the TracVision antenna.
Wait one minute for system startup.
Figure 3-13 Switchplate Power Switch
5. Using the receiver’s remote, go to the “Point Dish/
Signal Strength” screen (press MENU, 6, 1, 1 on most
models).
6. Choose Check Switch, then press SELECT.
7. Choose Test, then press SELECT.
MAINTENANCE
OFF
ON
