Installation manual
–
Mamba II
PREPARATION OF RG59 CABLE
When preparing the cable RG59 follow Figure 10:
unscrew the end of the joint;
put the rubber seal from the cable gland;
remove the isolation of the cable RG59 at distance 42 to 44 mm;
split shielding to separate wires;
wrap the shielding by tinned wire and keep 35-40 mm for
connection to a terminal;
remove the centre cable isolation and keep 15-20 mm;
fold the centre cable in half due to the amplification of diameter
of the cable. Keep about 12 mm because of terminal connection;
ensure that the length of both ends is at least 6 mm.
PREPARATION OF SENSTIVE CABLE
Preparation of sensoric cable describe following Fig.11):
unscrew the end of the joint;
put the rubber seal to the cable from the cable gland;
remove the isolation from 35 to 40 mm;
cut off the isolation foil about 9-11 mm from the left edge of
isolation;
cut off the shielding wire about 9-11 mm from the left edge of
isolation;
bend the cable shield (including foil) toward the existing
isolation;
wrap the shielding with tinned wire for a distance of 35-40 mm;
remove the isolation of all central wires at around 30- 32 mm;
put all centre wires together;
ensure that the length of the central wires are at least 6 mm.
CABLE CONNECTION
Fig.12:
Cable joint for connection of sensitive and non-sensitive cable
Fig. 11:
Preparation of detection cable
Fig. 10:
Preparation of RG59 cable
