Installation manual
–
Mamba II
2.
You can define some features of the sensor in this section:
Setting of sensitivity of
tilt detector (accelerometer)
–
tilt detector detects the tilt and removal of surface-
mounted, for example, in applications where the detector is connected by non-sensitive cable. Sensitivity can
be adjusted by moving the slider to the desired position - writing to memory start automatically.
You can adjust
minimal power
in the pop-up menu. You can define low level of power voltage, which activate
trouble output. This feature reduce the sensitivity adjust the digital input, the percentage sensor reduces its
sensitivity to input activation. Operating voltage range of the sensor is define in section 1.3 TECHNICAL
FEATURES AND CONDITIONS
–
writing to memory start automatically after selecting value in the menu.
You can adjust reducing of sensitivity in the pop-up menu
digital input.
Activation is performed by
connection terminal DI and PWR terminal (-). Writing to memory start automatically after selecting value in
the menu.
3.
Tampers TAB:
There is possibility to define activation events for tamper outputs NC2 and NC3 in this tab. You can split the
events for the both outputs or you can use just one output for all trouble events. Reed relay is hardware
connected just to the output NC2 and this setting is not possible to change in the software.
4.
Expert TAB:
The tab is used for detailed settings of algorithm and advanced sensor report.
WARNING!!!
All the values that you set in this menu, can affect the quality of detection and manufacturer cannot
guaranteed the full functionality of the product. Any changes in the settings, consult with your supplier.
