Installation manual
–
Mamba II
5. PROGRAMMING SOFTWARE
5.1. INSTALATION
Run the installation file "setup.exe" and follow the instructions during installation. After installation, you create a
shortcut "Mamba Soft 2" in the Start menu. Start the software.
5.2. CONTROL
After starting the main screen appears:
Fig. 14:
Main window
1.
Connection settings
–
you can set the parameters of the serial port for connection in this section. If you
connect locally or via RS485, locate the transmitter in the list of loaded devices. The software automatically
detect all devices connected to your computer. This procedure working only when the software starting, so
your converter has to be connected to a PC before start of the software.
Setting the address of the sensor is described in chapter 3.3. Controls
Speed of communication BUS is in default set to 19 200 Baud
–
do not change this setting. Is necessary to set
right address on RS485. This setting has to be realized by hardware DIP switch 4-8.
2.
Connection to the sensor
–
Press
Connect
to connect the sensor and the software automatically retrieves all
values from the sensor EPROM memory. After this operation, all settings in the menu start to available and
status of the sensor will be displayed.
WARNING!!!
All the values that you set in control software, rewrite manually adjusted values of the rotary switch on the
mainboard. And opposite - Each additional manual change on the rotary switch rewrites the software set
parameters. The software always reads the last set values from EPROM memory either HW or SW.
1
2
3
5
SECTION C1
SECTION C2
SECTION B
6
SECTION A
4
