3. Turning On
3.1 Turning On
Always
: -
Before turning on please ensure
that the
In-Line Pump Protection Filter
(shown across) is connected to the Gas
Sample Port (see 2.2 or 2.4).
**THIS MUST REMAIN ON THE UNIT
AT ALL TIMES.**
Failure to do so may result in pump failure
and will invalidate the warranty.
Press the
Power Key
for approximately 2 seconds and the TPI 717R will
start up and display ALL Segments on the display for approx. 1 second. The
717R will then enter its 30-second purge period, briefly displaying the Software
Version & Instrument Serial Number, before continuing with the countdown where
upon the following screen will be displayed.
The instrument should ALWAYS be turned
on in a clean air environment as the 30
second purge will attempt to set the
Carbon Monoxide level to 0 ppm and the
Oxygen to 20.9%.
If there is insufficient clean air in the sensor
chamber after the 30 second purge period an
error indicating this
may
be displayed, please
see troubleshooting guide (appendix D) for
appropriate remedy. If the error is still present
after attempting the suggested remedy please
call the
TPI HELPLINE
01293 530196 opt. 1
717R
Summary of Contents for 717R
Page 1: ...TPI 717R Combustion Flue Gas Analyser ...
Page 31: ......
