Toyota RAV 4 2019, Manual

Page: 583 / 728

583
7-3. Do-it-yourself maintenance
7
Ma
in
te
nance and
care
1
Park the vehicle in a safe
place, wait for approximately
20 minutes, and then start
the engine.
2
Press or of the meter
control switches on the steer-
ing wheel and select
.
3
Press or of the meter
control switches and select
“Vehicle Settings”, and then
press
.
4
Press or of the meter
control switches and select
“TPWS”, and then press
.
5
Press or of the meter
control switches and select
“Change Wheel”. Then press
and hold
until the tire
pressure warning light starts
slowly blinking 3 times.
The change wheel set mode is acti-
vated and registration is started.
Vehicles with a tire inflation pres-
sure display function only: Then a
message will be displayed on the
multi-information display. When
registration is being performed, the
tire pressure warning light will blink
for approximately 1 minute then illu-
minate and “--” will be displayed for
the inflation pressure of each tire on
the multi-information display.
6
Drive the vehicle at approxi-
mately 25mph (40 km/h) or
more for approximately 10 to
30 minutes.
When registration is completed, the
tire pressure warning light will go off
and the inflation pressure of each
tire will be displayed on the multi-
information display.
Even if the vehicle is not driven at
approximately 25 mph (40 km/h) or
more, registration can be com-
pleted by driving for a long time.
However, if registration does not
complete after driving for 1 hour or
more, perform the procedure again
from the beginning.
7
Initialize the tire pressure
warning system. (

P.579)
■ When registering ID codes
● ID code registration is performed
while driving at a vehicle speed of
approximately 25 mph (40 km/h)
or more.
● Before performing ID code regis-
tration, make sure that no wheels
with tire pressure warning valve
and transmitters installed are near
the vehicle.
● Make sure to initialize the tire
pressure warning system after
registering the ID codes. If the
system is initialized before regis-
tering the ID codes, the initialized
values will be invalid.