Toyota RAV 4 2019, Manual

Page: 315 / 728

315
4-5. Using the driving support systems
4
Driving
WARNING
● Do not use the panoramic view
monitor system in the following
cases:
• On icy or slick road surfaces, or
in snow
• When using tire chains or emer-
gency tires
• When the front door or the back
door is not closed completely
• On roads that are not flat or
straight, such as curves or
slopes
• If the suspension has been
modified or tires of a size other
than specified are installed
● In low temperatures, the screen
may darken or the image may
become faint. The image could
distort when the vehicle is mov-
ing, or you may become unable
to see the image on the screen.
Be sure to visually check all
around the vehicle both directly
and using the mirrors before
proceeding.
● If the tire sizes are changed, the
position of the guide lines dis-
played on the screen may
change.
● The camera uses a special lens.
The distances between objects
and pedestrians that appear in
the image displayed on the
screen will differ from the actual
distances. (

P.338)
● When an aftermarket part is
installed in the display area of
the screen.
NOTICE
● In panoramic view/moving
view/see-through view, the sys-
tem combines images taken
from the front, back, left and
right side cameras into a single
image. There are limits to the
range and content that can be
displayed. Familiarize yourself
with the characteristics of the
panoramic view monitor system
before using it.
● Image clarity may decline at the
four corners of the panoramic
view/moving view/see-through
view. However, this is not a mal-
function, as these are the
regions along the border of
each camera image where the
images are combined.
● Depending on lighting condi-
tions near each of the cameras,
bright and dark patches may
appear on the panoramic
view/moving view/see-through
view.
● The panoramic view/moving
view/see-through view display
does not extend higher than the
installation position and image
capture range of each camera.
● There are blind spots around
the vehicle. Accordingly, there
are regions not displayed in
panoramic view.
● Three-dimensional objects dis-
played in wide front view, rear
view or side view may not be
displayed in panoramic
view/moving view/see-through
view.