55
Resupplying the Water
(After draining)
1
Open the shutoff valve to
supply water.
●
•
Check that there are no leaks in the
plumbing or the NEOREST.
2
If the power plug is
disconnected, insert it.
(Page 15)
If the breaker on the distribution
board is set to OFF, switch it to
ON.
(Asia, Oceania, Middle East)
3
Discharge water from the wand.
(1) Pressing down the left side of the toilet seat,
(2) Press the [REAR] on the remote control
to discharge water from the wand.
(Catch the water in a paper cup or
other receptacle)
■
■
If the remaining water has frozen
and no water comes out
●
•
Heat the inside of the bathroom, and warm
the water supply hose and shutoff valve
using a cloth soaked in warm water.
4
Press [FLUSH] on
the remote control to
flush.
●
•
If there is no water in the
tank, you cannot flush the
toilet. Never operate the
toilet with no water in the
tank.
●
•
When the tank is filling with
water, the LED on the main
display will flicker. After
the tank is full, the LED
changes. (Tank filling time:
about 30 seconds)
5
After the bowl unit
fills with water, press
[FLUSH] again.
Reference
Maintenance
Operation
Introduction
Reference
Maintenance
Operation
Introduction
