8
Safety Precautions
(Continued)
CAUTION
If a water leak should occur, always close the shutoff valve.
When the ambient temperature is likely to drop to 0°C or lower, prevent
damage to the pipes and hoses due to freezing.
●
•
Frozen water pipes could cause the top unit and the pipes to break, resulting in a water leak.
●
•
Regulate the room temperature to prevent the pipes and hoses from freezing during cold months.
When not using the NEOREST over an extended period of time, drain the
water out of the top unit and the water supply hose, and pull the electrical
plug from the outlet.
Switch the breaker on the distribution board to OFF.
(Asia, Oceania, Middle East)
●
•
When using the product again, allow the product to refill with water first.
Otherwise, the water in the tank might become contaminated and cause skin inflammation or
other problems. (Refer to Page 55 for instructions on resupplying the water.)
●
•
Leaving the power on may cause fire or heat.
When installing the water filter drain valve, make sure that it is securely
tightened in its proper position.
●
•
Failure to securely tighten it may cause a water leaks.
If the bowl unit is clogged, disconnect the power plug and remove the clog.
Switch the breaker on the distribution board to OFF and remove the clog.
(Asia, Oceania, Middle East)
●
•
If the auto flush were allowed to function, it would make the wastewater in the bowl unit overflow
and may result in water damage.
●
•
Use any commonly available toilet plunger to remove the clogging.
Always flush, even after just urinating.
●
•
Failure to do so may cause inadequate flushing or clogging of the bowl unit, resulting in waste
water overflow and water damage.
Wipe condensation on the bowl unit, tank, water supply pipe and shutoff
valve with a dry cloth.
●
•
Condensation may cause staining and corrosion of the floor.
●
•
Ventilate the restroom to prevent condensation.
Wipe any urine, condensation, cleaner, water, etc. that has gotten on the
floor with a well-wrung mop or cloth.
●
•
Failure to do so may cause staining and corrosion of the floor.
