TOSOT DC INVERTER U-MATCH AIR
22
Figure 2-3-4 Enqu
iry and setting of wired controller’s address
3.2.3.2 Setting of Master/Slave Wired Controller’s Address
Under off status of the unit, press Enter/Cancel and Mode buttons at the same time for 5s to go to
the enquiry and setting interface of master/slave wired controller. In this case, LCD displays wired
controller’s address (01 for master wired controller and 02 for slave wired controller). Press ▲ or ▼
button to adjust address of master/slave wired controller and then press Enter/Cancel button to confirm.
If slave wired controller is set, the icon
will be displayed.
NOTE:
If there is only one wired controller, it only can be set as the master; If there are two wired
controllers, one should be the master and the other should be the slave.
Setting of maste
r/slave wired controller’s address is shown as Figure 2-3-5 below:
