TOSOT DC INVERTER U-MATCH AIR
17
No.
Name
Function Description
FAN
button
By pressing this button, Auto, Low, Middle, High speed can be circularly selected. After power on, Auto fan
speed is default.
Low speed
Middle speed
High speed
NOTE:
Under the DRY mode, the fan will be kept running at the low speed and the fan speed isn't adjustable.
SWING
UP/DOWN
button
Press this button to set up the swing angle, which circularly changes as below:
When the guide louver starts to swing up and down, if SWING functions is canceled, the air guide louver will
stop and remains at the current position.
indicates the guide louver swings up and down among those five directions.(Simplified SWING function
applicable for some Fan Coil Units: When the wireless remote controller is energized initially with the unit
under the OFF status, it should be set by pressing the + button and the SWING button simultaneously, with
the symbol
blinking twice. Then, after the unit is turned on, this function can be activated by pressing
the SWING button, with the displayed symbol
indicating swing function is on and without this displayed
symbol indicating swing function is off.)
CLOCK
button
By pressing this button, the clock is allowed to be set, with
blinking, and then press the +/- button to
adjust the clock within 5 seconds. If the +/-button is pressed down constantly for more than 2 seconds, the
clock setting will be increased or decreased 10 minutes every 0.5 seconds. After that, another press on the
CLOCK button accepts the setting. 12:00 is the default, when the wireless remote controller is energized.
TIMER ON
button
When TIMER ON is activated, ON will blink while the symbol
will disappear. Within 5 seconds it is
allowed to set the ON time by pressing the +/- button. Each press will make the time increase or decrease
one minute. Besides, the time can also be set by pressing the +/- button constantly. that is, in the early 2.5
seconds, the time will increase/decrease quickly per single minute, and in the late 2.5, the time will
increase/decrease per ten minutes. After the desired time value is set, press TIENE ON again to conform
the setting within five seconds. After that, another press on TIMER ON will cancel the setting. Prior to this
setting, the clock shall be set to the actual time.
X-FAN
button
Pressing this button can activate or deactivate the X-FAN function. In Cool or Dry mode, by pressing this
button, if "
" is displayed, it indicates the X-FAN function is activated. By repressing this button, if "
"
disappears, it indicates the X-FAN function is deactivated. After energization, X-FAN OFF is defaulted. If
the unit is turned off, X-FAN can be deactivated but can't be activated.
TEMP
button
By pressing this button it is allowed to select displaying the indoor setting temperature or the indoor ambient
temperature.
Indoor setting temperature is default after the indoor unit is energized initially.
By pressing the TEMP button, when the temperature symbol
is displayed, the indoor displayer will
show the indoor setting temperature; when
is displayed, it will show the indoor ambient temperature;
when
is invalidation, If current displays indoor ambient temperature, if received the other remote
control signal, it will display presetting temperature, 5s later, will back to display the ambient temperature.
(This function is applicable to partial of models.)
TIMER
OFF
button
By pressing this button it is available to go to the TIMER OFF setting state with the same setting method as
that of the TIMER ON, in which case the OFF symbol blinks.
