TDP-MT8 Service Guide
28
Remove and Replace the Focus and Zoom Rings
The
focus ring
fits around the front of the projection lens. The
zoom ring
is behind the focus ring. The
lens cap
snaps onto the focus ring.
Both the focus ring and the zoom ring snap into place on the lens barrel. They can be replaced without
removing any other projector parts.
Three retainer slots inside the zoom ring engage alignment pins on the outside of the lens. Three retainer
tabs on the zoom ring engage holes on the lens barrel.
1.
Place the projector right side up on a soft work surface.
2.
Grasp the focus ring and pull it off of the lens barrel. The retainer slots disengage the pins on the
lens.
Summary of Contents for TDP-MT8
