TDP-MT8 Service Guide
47
Remove and Replace the Rear and Side IR Receivers and Lenses
The
rear IR receiver
fastens to the chassis, while the
left side IR receiver
and
right side IR receiver
are each fastened to the sides of the bottom case. The left and right side IR receivers are as you view
them from the front of the projector.
Each of the side IR receivers are protected by a
side IR lens
. The rear IR receiver is protected by the
rear IR lens
in the rear bezel.
Any of the IR receivers or lenses above may be replaced separately. If you need to replace the rear IR
lens, see Remove and Replace the Rear Bezel on page 51 for information.
1.
Remove the following items:
Outer handle (see page 41)
Rear bezel (see page 51)
Top case (see page 57)
Fan assembly (applies to rear IR receiver only) (see page 26)
Rear IR Receiver
1.
Unplug the rear IR receiver cable from J518 on the controller ECA.
2.
Remove the two M3x8 Torx screws that fasten the rear IR receiver to the chassis.
Assembly Notes
♦
Route the cable to the inside of the rear IR receiver ECA.
Summary of Contents for TDP-MT8
