Toshiba Stratagy Flash, Installation Manual

Page: 40 / 56

Maintenance
Tools
28
Stratagy Flash Installation Guide 02/02
Upgrade Stratagy Flash Software
Notes
•
Make a copy of the new software disks as a backup. Destination disks should be scanned
first for viruses and the new disks write protected after the copies are made.
•
It is recommended that you back up any database prior to starting any upgrade procedure.
•
Loading the Stratagy Admin software can be done before/after connecting the Stratagy
Admin PC to the Stratagy Flash.
To upgrade Stratagy Flash system software, you need the correct set of upgrade disk(s).
CAUTION! Because of possible errors that can be induced through the telephone network,
Toshiba advises that you perform the Upgrade Utility on site.
Step 1: Load Stratagy Admin Software (VSA.3x)
1. Insert the Stratagy Admin disk into the floppy disk drive of the Stratagy Admin PC.
2. Access the DOS prompt (
C:\
).
3. To begin the installation procedure, type
a:install c:\VSA3x
where: x = the version letter of the Admin software you are installing.
CAUTION! Do not install the Stratagy Admin VSA.3x software into an existing
Stratagy Flash Admin2 or Admin3 directory used for Release 2 systems. If you
do, file corruption can occur when communicating with a Stratagy Flash.
4. Press any key to continue. The Stratagy Admin program is installed on drive C: in subdirectory
VSA3x
.
Step 2: Upgrade Stratagy Flash Software
1. From the DOS prompt (C:\VSA3), type
admin
and press
Enter
.
Important!
The Stratagy Admin PC must be configured for the correct serial port in Stratagy
Admin prior to performing the next step. (See the Stratagy R3 I&M, Chapter 3 –
Configure Stratagy for configuration instructions.)
2. Press
1
or highlight the Connect to Stratagy option and press
Enter
. The Admin software
prompts for the system password.
3. Enter the password and press
Enter
. The Stratagy Admin software checks for the Stratagy
Admin PC’s connection to Stratagy and then displays the Main Menu.
4. Press
Alt+t
for the Tools submenu. You are prompted for your password.
5. Enter the password (the default is
Stratagy
) and press
Enter
. The Tools submenu displays.
6. From the Tools menu, press
3
. The Upgrade screen displays.
7. Place the upgrade disk into the Stratagy Admin PC’s floppy-disk drive.
8. The default directory is A:. If you need a different drive, type over the default. Press
Enter
.
9. When the upgrade procedure is complete, press any key to reboot. If the software was loaded
from the Stratagy Configuration Utility menu, the system restarts and the Main Menu displays.
If the software was loaded from the DOS prompt, the DOS prompt displays.