Toshiba Stratagy Flash, Installation Manual

Page: 31 / 56

Installation
Step 11: Configure Stratagy Flash
Stratagy Flash Installation Guide 02/02
19
adpcm_hq
Sets the sampling rate for outgoing greetings. The higher the sampling rate, the
better the sound quality; however, the amount of disk space used is also higher. The
recommended value for the Stratagy Flash is 24; for all other Stratagy systems, the
recommended value is 64.
CAUTION! If you change this parameter on an active system, all previously
recorded greetings are lost.
Possible values: 24, 32, 64
Default: 24
adpcm_nq
Sets the sampling rate for incoming messages. The higher the sampling rate, the
better the sound quality; however, the amount of disk space used is also higher. The
recommended value for the Stratagy Flash is 24; for all other Stratagy systems, the
recommended value is 32.
CAUTION! If you change this parameter on an active system, all previously
recorded messages are lost.
Possible values: 8, 24, 32, 64
Default: 24
adpcm_pq
Sets the sampling rate for the system prompt file. This is predetermined by the
sampling rate at which the system prompt file was recorded. The recommended
value for the Stratagy Flash is 24; for all other Stratagy systems, the recommended
value is 64.
CAUTION! Do not change this value unless you have installed the
appropriate system prompt file.
Possible values: 8, 24, 32, 64
Default: 24
pbx_type
Defines the Strata DK model that is used as the host system.
Possible values: DK8, DK16, DK16E, DK24, DK56, DK96, DK14/40, DK14/40S
(DK24/40 with SMDI), DK280, DK280S (DK280 with SMDI),
DK424, DK424S (DK424 with SMDI), P4000
Default: DK14/40
trace_cap
Defines the size of the TRACE.OUT file in kilobytes. When the size of the file
reaches its defined maximum, new data begins to overwrite the oldest data in the file,
generating a continuous loop of information.
Possible values: Values vary depending on the amount of Trace information
required and the space available in Stratagy’s flash memory. If this value is set
high, it affects the amount of memory available for message storage and can
take an excessive amount of time to copy the file to the Stratagy Admin PC. A
standard setting of 1440 enables you to copy the file to the Stratagy Admin PC’s
floppy disk drive.
Default: 1024 (kilobytes = 1 megabyte)
Table 2 Stratagy Flash System Configuration Parameters – Definitions and Settings (continued)
Parameter Description