8-EN
7-EN
– 4 –
EN
1
Precautions for safety
The manufacturer shall not assume any liability for the damage
caused by not observing the description of this manual.
WARNING
General
• Before starting to install the air conditioner, read carefully
through the Installation Manual, and follow its instructions to
install the air conditioner.
• Only a quali
fi
ed installer(*1) or quali
fi
ed service person(*1) is
allowed to install the air conditioner. If the air conditioner is
installed by an unquali
fi
ed individual, a
fi
re, electric shocks,
injury, water leakage, noise and/or vibration may result.
• Do not use any refrigerant different from the one speci
fi
ed
for complement or replacement. Otherwise, abnormally high
pressure may be generated in the refrigeration cycle, which
may result in a failure or explosion of the product or an injury to
your body.
• When transporting the air conditioner, use a forklift and when
move the air conditioner by hand with 4 peoples.
• Before carrying out the installation, maintenance, repair or
remove work, be sure to set the circuit breaker to the OFF
position and being performed under Lockout/Tag out.
• Only a quali
fi
ed installer(*1) or quali
fi
ed service person(*1) is
allowed to undertake work at heights using a stand of 50 cm or
more.
• Wear protective gloves and safety work clothing during
installation, servicing and removal.
• Do not touch the aluminum
fi
n of the outdoor unit. You may
injure yourself if you do so. If the
fi
n must be touched for some
reason,
fi
rst put on protective gloves and safety work clothing,
and then proceed.
• Do not climb onto or place objects on top of the outdoor unit.
You may fall or the objects may fall off of the outdoor unit and
result in injury.
• When working at heights, use a ladder which complies with the
ISO 14122 standard, and follow the procedure in the ladder’s
instructions. Also wear a helmet for use in industry as protective
gear to undertake the work.
• When cleaning the
fi
lter or other parts of the outdoor unit, set
the circuit breaker to OFF without fail, and place a “Work in
progress” sign near the circuit breaker before proceeding with
the work.
• When working at heights, put a sign in place so that no-one will
approach the work location, before proceeding with the work.
Parts and other objects may fall from above, possibly injuring a
person below.
• You shall ensure that the air conditioner is transported in stable
condition. If any part of the product is broken, contact the
dealer.
• Do not modify the products. Do not also disassemble or modify
the parts. It may cause a
fi
re, electric shock or injury.
• This appliance is intended to be used by expert or trained users
in shops, in light industry, or for commercial use by lay persons.
About the refrigerant
• This product contains
fl
uorinated greenhouse gases.
• Do not vent gases to the atmosphere.
• The appliance shall be stored in a room without continuously
operating ignition sources (for example: open
fl
ames, an
operating gas appliance or an operating electric heater).
• Do not pierce or burn refrigerant cycle parts.
• Do not use means to accelerate the defrosting process or to
clean, other than those recommended by the manufacturer.
• Be aware that refrigerants may not contain an odour.
