MicroMAS Installation Guide
Installation
Micro MAS Installation Guide 4/07
3
Step 4: Remove Cover
1. Once the unit is operational, shut down Windows, turn the power off and remove the power
cable.
2.
Remove the two screws from the upper left and right corners of the back of the server. Pull the
cover off using the build-in handle.
Step 5: Unpack Voice / Fax-modem Boards
³
Unbox the Dialogic voice (Dialogic part number D4PCIUF/S) and/or MultiTech System Fax-
modem (MultiTech part number MT5634ZPX-PCI) board(s) to be installed in this system.
Note
MicroMAS only supports half-length PCI boards.
Step 6: Install Voice/Fax
Board(s)
1. Loosen the riser retaining bar by pulling
on the release tab and lifting the Bar to
unlock it (shown right).
2.
Remove the PCI riser screw, then
remove the PCI riser by pulling the riser
upwards with the green strap.
3.
Insert the edge connector of the first
board into the PCI 1 slot (see
).
Apply pressure only to the top edge of
the board, and gently rock the board
back and forth to seat the edge
connector into the slot.
4.
Insert the second board into the PCI 2
slot.
Note
A Dialogic Voice board can be installed in the PCI 1 (top) slot with no modification. To
install a fax-Modem card into the PCI 1 card slot the green strap must first be removed
from the riser. The fax-modem card can be installed in the PCI 2 slot without modification.
Figure 2
MicroMAS Internal View 2
Release Tab
Riser
Retaining Bar
001-MM
Figure 1
MicroMAS Internal View 1
002-MM
Power Supply
PCI Riser
CPU Fan
Retaining Bar
Chassis Fan
RAM Slot
PCI 1 Card
PCI 2 Card
