32
8
Operational description
This chapter describes the working circuit and control of Air to Water Heat Pump about the following operations.
Item
Page
8-1
8-2
8-2. Operation Mode and Control Method
1) Heat pump operation range of hot water supply, heating and cooling
5) Simultaneous operations of "hot water supply" and "heating"
6) Simultaneous operations of "hot water supply" and "cooling"
8) Hot water boost operation
9) Anti bacteria (ANTI BACTERIA) operation
10) Night set back (NIGHT SET BACK) operation
11) FROST PROTECTION operation
13) Night time low-noise operation
8-3
1) Capacity control (compressor, high-temperature release, low-temperature release)
5) Mixing Valve control (2-temperature heating control)
6) Room temperature control
7) Room temperature control with the thermostat
8) Hot water cylinder thermostat control
9) Control of force stop and restart
10) Control of limit of heat pump operation
11)Output signal control 1
12)Output signal control 2
13) Q-H characteristics of hydro unit
15) Piping freeze prevention control
16) High return water protect control
48 to 64
8-4
1) PMV (Pulse motor valve) control
2) Discharge temperature release control
4) Current releases shift control
5) Outdoor fan control
8) Short circuit operation prevention control
9) Over current protection control
10) High pressure release control
11) Compressor case thermostat
12) Bottom plate heater control
AMP Air Conditioning
www.ampair.co.uk | [email protected]