Toshiba GRL150-100 Series, Instruction Manual

Page: 117 / 267

⎯
116
⎯
6 F 2 S 0 8 2 8
Selection of LEDs
•
Select "LED" on the "Set.(change)" screen to display the "LED" screen.
/ 2 L E D
•
L E D
•
V i r t u a l L E D
Selection of real LEDs
•
Select "LED" on the "/2 LED" screen to display the "/3 LED" screen.
/ 3 L E D
•
L E D 1
•
L E D 2
•
L E D 3
•
Select the LED number and press the ENTER key to display the "LED
∗
" screen.
/ 4 L E D
∗
•
L o g i c / R e s e t
•
F u n c t i o n s
Setting the logic gate type and timer
•
Select "Logic/Reset" to display the "Logic/Reset" screen.
/ 5 L o g i c / R e s e t
L o g i c 0 _
O R / A N D
R e s e t 0
I n s t / L a t c h
•
Enter 0(=OR) or 1(=AND) to use an OR gate or AND gate and press the ENTER key.
•
Enter 0(=Instantaneous) or 1(=Latched) to select the reset timing and press the ENTER key.
•
Press the END key to return to the "LED
∗
" screen.
Note:
To release the latch state, refer to Section 4.2.1.
Assigning signals
•
Select "Functions" on the "LED
∗
" screen to display the "Functions" screen.
/ 5 F u n c t i o n s
I n # 1
2 1 _
I n # 2
1 1
I n # 3
2 4
I n # 4
0
•
Assign signals to gates (In #1 to #4) by entering the number corresponding to each signal
referring to Appendix B.
Note:
If signals are not assigned to all the gates #1 to #4, enter 0 for the unassigned gate(s).