Toshiba e-studio281c, Service Manual, Page: 240 / 414

e-STUDIO281c/351c/451c © 2005 - 2008 TOSHIBA TEC CORPORATION All rights reserved
PAPER FEEDING SYSTEM
10 - 26
[D-2] Lower transport clutch (Low speed) (CLT15)
(1) Take off the tray drive unit with the bracket
( P.10-25 "[C-2] Tray drive unit").
(2) Remove 3 screws and take off the bracket.
Notes:
1. Do not push the transport roller shaft
strongly when installing the bracket and
tighten the screws in the order of A, B and
C.
2. When the installation is finished, open the
side cover and check if the transport roller
rotates smoothly.
Fig. 10-56
(3) Take off the paper feed guide assembly (
P.10-27 "[F] Paper feed guide assembly").
(4) Remove 1 clip from the transport roller.
Slide the transport roller to the rear side and
remove it from the bushing on the front side.
Then pull out the roller slantwise to the front
side.
Fig. 10-57
(5) Disconnect 1 connector and take off the
lower transport clutch (low speed).
Notes:
1. Hook the harness of the clutch onto the
harness holder. Be sure that the harness
is not tightened extremely.
2. When the clutch is being installed, be
sure that the stoppers of the clutch and
harness holder are placed at the right
positions.
Fig. 10-58
Bracket
C
B
A
1
2
Connector
Lower transport clutch (Low speed)
Harness holder
05/08