Toshiba e-studio281c, Service Manual, Page: 239 / 414

10
© 2005 - 2008 TOSHIBA TEC CORPORATION All rights reserved e-STUDIO281c/351c/451c
PAPER FEEDING SYSTEM
10 - 25
[C-2] Tray drive unit
[D] Transport clutch
[D-1] Lower transport clutch (High speed) (CLT16)
(1) Remove the upper and lower drawers.
(2) Take off the filter bracket
( P.2-41 "[K] FIL board (FIL)").
(3) Disconnect 1 connector. Remove 4 screws
and take off the tray drive unit with the
bracket.
Fig. 10-53
(1) Take off the tray drive unit with the bracket
( P.10-25 "[C-2] Tray drive unit").
(2) Remove 3 screws and take off the bracket.
Notes:
1. Do not push the transport roller shaft
strongly when installing the bracket and
tighten the screws in the order of A, B
and C.
2. When the installation is finished, open the
side cover and check if the transport roller
rotates smoothly.
Fig. 10-54
(3) Disconnect 1 connector and take off the
lower transport clutch (High speed).
Notes:
1. Hook the harness of the clutch onto the
harness holder. Be sure that the harness
is not tightened extremely.
2. When the clutch is being installed, be
sure that the stoppers of the clutch and
harness holder are placed at the right
positions.
Fig. 10-55
Tray drive unit
Bracket
C
B
A
Connector
Harness
holder
Lower transport clutch (High speed)
05/08