Toshiba e-studio281c, Service Manual, Page: 170 / 414

e-STUDIO281c/351c/451c © 2005 - 2008 TOSHIBA TEC CORPORATION All rights reserved
SCANNER
6 - 26
[J] Platen sensor (S7) / Carriage home position sensor (S6)
(3) Detach the tension springs of the front and
rear sides.
(4) Remove the carriage wires.
Fig. 6-42
(5) Rotate the carriage-2 in the direction where
the inside of the frame is dented shown in
the figure at right, not to touch the mirrors.
Then take off the carriage-2.
Notes:
1. When replacing the mirrors-2 and -3,
replace the carriage-2 together with mir-
rors-2 and -3. Mirrors-2 and -3 should not
be removed.
2. When installing carriage-2, fix the bracket
temporarily at the position (A). Then
move it to the direction (B), push it to the
end and fix securely.
(
P.6-25 "Fig. 6-39 ")
Fig. 6-43
(1) Take off the upper rear cover.
( P.2-32 "[T] Upper rear cover")
(2) Disconnect 1 connector. Release the latches
and take off the platen sensor.
(3) Remove the seal.
(4) Disconnect 1 connector. Release the latches
and take off the carriage home position sen-
sor.
Fig. 6-44
Platen sensor
Carriage
home position sensor