e-STUDIO203S/203SD TEST COMMAND, TROUBLE CODES 10 - 3
4. Descriptions of various test commands
Main
code
Sub
code
Contents
Details of function/operation
1
01
Mirror scan (SCAN CHK)
[Function]
When [ENTER/START] key is pressed, the home position is checked and the mirror base per-
forms full scan at the speed of the set magnification ratio.
During operation, the set magnification ratio is displayed.
The mirror home position sensor status is displayed with the “COPY mode lamp”. (When the
mirror is in the home position, the lamp lights up.)
During operation, the copy lamp lights up.
When [C] key is pressed, if the operation is on the way, it is terminated and the machine goes to
the sub code entry standby mode.
[Operation]
02
Mirror home position sensor
(MHPS) status display
(MHP-SENSOR)
[Function]
Monitors the mirror home position sensor, and makes the "COPY mode lamp" turn on during
the sensor ON status.
[Operation]
06
Mirror scan aging (SCAN
AGING)
[Function]
When [ENTER/START] key is pressed, the mirror base performs full scan at the speed of the
set magnification ratio.
During operation, the set magnification ratio is displayed.
After 3sec, the mirror base performs full scan again.
∗
When [ENTER/START] key is pressed once, the ready lamp remains OFF.
The mirror home position sensor status is displayed on the "COPY mode lamp." (The lamp is
ON when the mirror is in the home position.)
During aging, the copy lamp is ON.
[Operation]
The operation is similar to test command 1-01.
2
01
Reversing Automatic
Document Feeder (RADF)
aging
(ADF AGING)
[Function]
When [ENTER/START] key is pressed, the set magnification ratio is acquired and duplex docu-
ment transport is performed in the case of RADF.
However, the operating conditions don't matter and the operation is not stopped even in case of
a jam. Also the magnification ratio is displayed on the LCD.
[Operation]
The operation is similar to test command 1-01.
02
RADF sensor status display
(ADF SENSOR)
[Function]
The ON/OFF status of the RADF sensors can be checked with the LCD.
When a sensor is ON, the sensor name is displayed on the LCD.
[Operation]
03
RADF motor operation check
(ADF MOTOR CHK)
[Function]
When [ENTER/START] key is pressed, the motor rotates for 10sec at the speed corresponding
to the set magnification ratio.
[Operation]
The operation is similar to test command 1-01.
1) Initial display
2) [ZOOM]
2) [
←
]
2) [
→
]
3) [ENTER/START]
01-01 SCAN CHK
- 100% +
01-01 SCAN CHK
- 78% +
01-01 SCAN CHK
- 99% +
01-01 SCAN CHK
- 101% +
01-01 SCAN CHK
EXECUTING... - 78% +
1) Initial display
01-02 MHP-SENSOR
EXECUTING...
Sensor
Display item
Document set sensor
SPID
RADF document transport sensor
SPPD
RADF paper feed cover open/close sensor
SDSW
RADF paper exit sensor
SPOD
1) Initial display
2) When the sensor is ON:
02-02 ADF SENSOR
02-02 ADF SENSOR
SPID SPPD SDSW SPOD
