e-STUDIO203S/203SD SPECIFICATIONS 2 - 2
3. Copy performance
*1: The first-copy time is measured after the power save indicator turns off following power on, using the document glass with the polygon rotat-
ing in the copy ready state and "Selection of copy start state" set to ON in the user programs (8-1/2" x 11" (A4), paper fed from paper tray).
The first-copy time may vary depending on machine operating conditions and ambient conditions such as temperature.
Fusing section
Fusing system
Heat roller system
Upper heat roller
Type
Teflon roller
Lower heat roller
Type
Silicon rubber roller
Heater lamp
Type
Halogen lamp
Voltage
120V
Power consumption
800W
Electrical section
Power source
Voltage
120V
Frequency
Common use for 50 and 60Hz
Power consumption
Max.
Less than 1000W
Average (during copying)
380Wh/H
Average (stand-by)
80Wh/H
Pre-heat mode
28Wh/H
Auto power shut-off mode
12.5W or less
Section, item
Details
Copy magnification
Fixed magnification
ratios
4 Red 3 Enlargement
(Inch system: 25, 50, 64, 78, 100, 129, 200, 400%)
(AB system: 25, 50, 70, 86, 100, 141, 200, 400%)
Zooming
magnification ratios
25 - 400% (376 steps in 1% increments)
50 - 200% when using RADF (151 steps in 1% increments)
Manual steps (manual, photo)
5 steps
Copy speed (CPM)
First-copy time *1
(Approximately)
8.0 seconds (When user program 24 is set to OFF)
10.7 seconds (When user program 24 is set to ON)
(paper: A4 (8-1/2" x 11"), exposure mode: AUTO, copy ratio: 100
Inch system
8-1/2" x 11"
(Landscape)
Same size
20
AB system
A4 (Landscape)
Same size
20
AB system
B5 (Landscape)
Same size
20
Max. continuous copy quantity
99
Void
Void area
Leading edge
1 - 4mm
Trailing edge
4mm or less
Side edge void area
0.5mm or more (per side)
4.5mm or less (total of both sides)
Image loss
Leading edge
same size: 3.0mm or less (OC) / 4mm or less (RADF)
Enlarge: 1.5mm or less (OC) / 3mm or less (RADF)
Reduction (50%): 6.0mm or less (OC) / 8mm or less (RADF)
Warm-up time
0 sec.
Immediately the ready lamp is lit.
Power save mode reset time
0 sec.
Immediately the ready lamp is lit.
Paper jam recovery time
0 sec.
∗
Jam recovery condition: Recovery time from 60 sec of door open.
Section, item
Details
