2. PRINTER SETUP
ENGLISH VERSION EO1-33094
2.6 Printer Setting
E2-21
2.6.2 Parameter Setting
(Cont.)
(11) WEB PRINTER
Select whether to use the printer as a web printer.
When the web printer is enabled, the status of the printer
connected to a network can be monitored through the web
browser.
•
OFF
Disables web printer function
•
ON INTERNAL Enables web printer function (using internal
memory)
•
ON EXTERNAL Enables web printer function (using an
external usb memory)
(12) RBN NEAR END
Select the remaining ribbon length when the ribbon near end is
detected.
•
OFF
Ribbon near end is not detected.
•
30m
Ribbon near end is detected when the remaining
ribbon is 30-m long. (Equivalent to ribbon
diameter of 38 mm)
•
70m
Ribbon near end is detected when the remaining
ribbon is 70-m long. (Equivalent to ribbon
diameter of 43 mm)
(13) EX.I/O
Select the type of expansion I/O interface operating mode. This
parameter needs to be set depending on the expansion I/O
control specification of the device to be connected via the
expansion I/O interface.
•
TYPE1 Standard
mode
•
TYPE2
In-line mode
(14) LBL/RBN END
Select the operation to be performed when a label end or ribbon
end is detected.
•
TYPE1
When a label/ribbon end is detected in the
middle of printing, the printer immediately stops
printing.
•
TYPE2
Selectable only when the ribbon saving function
is not activated.
When a label/ribbon end is detected in the
middle of printing, the printer prints the half-
finished label as far as possible, and stops when
the next label is at the home position.
(15)
MAXI CODE
Select the Maxicode specification.
•
TYPE1
Compatible with the current version
•
TYPE2
Special specification
NOTE:
The type specified by the
command may differ from the
actual mode, depending on
the status of this parameter.
Also, the data transmission
method is slightly different.
For details, refer to the
External Equipment Interface
Specification.
NOTE:
Since detecting the remaining
ribbon length has a margin of
error, use the specified length
as a guide.
