74
75
Deutsch
English
Deutsch
English
5.4 Transom mount
The tilt mechanism allows both tilting and trimming the motor.
You can tilt the motor to remove it from the water (e.g. when it is not in use or when you
land the boat in shallow water).
Trimming allows you to set the motor perfectly to the water surface. For this there are 4
possible trimming positions.
See chapter 4.1 (Fitting the drive onto the boat) to find out how to tilt and trim the motor.
The kick lever in the “Tilt/Auto kick-up” position enables the motor to be kicked up if it
touches the bottom. In this position it is not possible to reverse at full speed.
Automatic kick-up is switched off in the “Lock” position. This enables reversing at full
speed.
• Please ensure that the kick lever for
revers drive is in the “Lock” position.
Display
Cause
What to do
E02
Stator over-temperature
(motor overheating)
Motor can be used again after a short wait about 10 mi-
nutes). Contact Torqeedo Service.
E05
Motor/propeller blocked
Switch main switch to ”OFF” position, then remove
blockage and turn propeller one revolution by hand.
Reconnect motor cable
.
E06
Voltage in the motor too
low
Low battery charging status. Motor can potentially be used
again slowly from the stop position.
E07
Motor overcurrent
Continue at low output.
E08
Circuit board overheating
Motor can be used again after a short wait about 10 mi-
nutes). Contact Torqeedo Service.
E21
Tiller calibration defective
• Re-calibrate: Press “cal” button for 10 seconds.
• The display shows “cal up”: Press tiller forward to full
gas then press the “cal” button.
• The display shows “cal stp”: Return tiller to central posi-
tion then press the “cal” button.
• The display shows “cal dn”: Press tiller backward to full
gas then press the “cal” button.
E22
Magnetic sensor defective
Re-calibrate (refer to E21)
E23
Value range false
Re-calibrate (refer to E21)
E30
Motor communication
error
Check the motor cable’s plug-in connection. Check the
motor cable for damage.
E32
Tiller/Remote throttle
Check the plug-in connections. Check the cable
.
E33
General communication
error
Check the plug-in connections and cables. Switch the
motor off and on again.
E41, E42
Incorrect charging voltage
Use a Torqeedo power supply. If the error occurs in spite
of using a Torqeedo power supply, wait untill the battery
dissipates the overcharge. Should the error persist please
contact Torqeedo Service.
E43
Battery empty
Charge battery. Motor can potentially be used again slowly
from the stop position.
E45
Battery overcurrent
Switch motor off and on again. If this error occurs the
battery status indicator and range display can no longer
operate until the battery has been fully charged again.
E46
Battery operating tempe-
rature error
Battery cells outside operating temperature between -20°C
and +60°C (-4°F to 140°F). The motor can be used again
when the temperature has stabilized.
E 48
Charging temperature
error
Charging will continue when the cell temperature is
between 0°C and +45°C (32°F to 113°F).
Other error
codes
Faulty
Contact Torqeedo Service and notify them of the error
code.
No blinking
during charge
process, no
function of tiller-
display during
charge process
Battery does not charge
Contact Torqeedo Service.
