62
63
Deutsch
English
Deutsch
English
Connecting of Cruise 4.0 R/T to two Power 26-104 batteries
After battery installation transfer battery bank data, via remote throttle, to on-board
computer (chapter 5.3, „Set-up mode“) to be up to date about state of charge and range.
• Incorrect configuration of lithium batteries leads to much higher short
circuit currents than configurations with lead batteries. That is why you
must follow the installation instructions very carefully and only use the
Torqeedo cable set to connect your motor.
4.6.2 Cruise 4.0 R/T
Cruise 4.0 R/T operates with a power supply of between 42 V and 58 V (referring to
nominal voltage). This means it may be operated with at least two Power 26-104 lithium-
batteries.
The connection for the Cruise 4.0 R/T to 2 Power 26 -104 is the same as for Cruise 2.0 R/T
(refer to chapter 4.6.1). Moreover please connect both Power 26-104 from positive ter-
minal of first battery to negative terminal of second battery with cable bridge. Moreover,
also connect both data sockets of Power batteries to each other. Terminal connection will
then be as follows:
connection of high
current plug
switch main
switch of cable set
to “OFF”
connection of
data cable
connection of
data cable
connection of po-
sitive and negative
terminal posts
(see positive and
negative polarity on
imprint on battery
and terminal posts)
negative terminal post
Datenbuchse
Datenbuchse
positive terminal post
black cable: negative
red cable positive
