Ignition Switch Installation (continued)
g302112
Figure 290
2. Connect the ignition switch.
g302096
Figure 291
3. Install and hand tighten the Philips head screw to the control panel.
4. Connect the battery by installing the positive battery cable first, then the
negative cable to the battery.
Ignition Switch Testing
The ignition switch makes the proper connections for the starter, safety
circuits, and accessories. Detents inside the switch control the three switch
positions: OFF, RUN, and START. The START position is spring loaded so that it
automatically returns to the RUN position when released.
Ignition Switch Wiring Connections
Electrical System: Service and Repairs
Page 8–18
TIMECUTTER® Service Manual
3433-938 Rev A
Summary of Contents for TIME CUTTER ZS 4200S
