Toro TIME CUTTER ZS 4200S, Service Manual

Page: 199 / 215

Motion Control and Seat Switch Installation (continued)
4. Install the smart speed knob to the smart speed lever. Hand tighten with the
screw securing the smart speed knob to the smart speed lever.
g301691
Figure 279
5. Place the LH pod into position on the machine.
6. Move the motion control from the neutral position to the neutral lock position.
7. Install the fuel cap on the LH side pod.
8. Install the 3 screws (per pod) securing the pod to the pod support brackets.
Torque screws to 11 N • m (100 in-lb).
9. Flip the seat back into position.
Seat Switch Testing
1. Disconnect the wire harness from the Operator Presence Switch (seat
switch), located on the bottom of the seat assembly.
2. Using a digital multi-meter set to the OHM or Continuity setting, test the
continuity between the two switch terminals.
• When the seat is vacated, the switch should NOT have continuity (open)
• When the operator is present, the switch should have continuity (closed)
Neutral Lock Switch Testing
The neutral switch is a single pole plunger type switch (normally open) with
two terminals. When the plunger is depressed, the circuit closes and there is
continuity between the terminals.
•
Motion Control Levers in neutral park position (OUT), the switch should have
continuity (closed)
•
Motion Control Levers in the operating position (IN), the switch should NOT
have continuity (open)
TIMECUTTER® Service Manual Page 8–11 Electrical System: Service and Repairs
3433-938 Rev A