Toro TIME CUTTER ZS 4200S, Service Manual

Page: 120 / 215

Motion Control Actuator Installation
1. Install the motion control actuator onto the machine.
2. Connect the switch to the connector. Install the motion control neutral switch
into the steering control box by depressing the tabs on either side of the
switch.
3. Install the top T-30 screw and 7/16 inch nut securing the damper to the
chassis and motion control actuator. Torque screw and nut to 11 N • m (100
in-lb).
4. Install the 2 (9/16 inch) bolts per motion control arm. Torque bolt to 40.5–44.5
N • m (30–33 ft-lb).
5. Install the cubbie by lifting the front of each pod to maneuver the cubbie
onto the chassis.
6. Move the smart speed selector to the trim/turtle position.
7. Install the 2 screws (T-20) securing the cubbie to the chassis. Torque screws
to 11 N • m (100 in-lb).
8. Install the 2 (T-30) front pod mounting screws. Torque the screws to 11 N •
m (100 in-lb).
9. Install the fuel tank to the chassis. Install the 2 strap fasteners to the bottom
of the fuel tank.
g301705
Figure 160
10. Uncap the hoses. Install the fuel hose and fuel vent hose to the fuel tank
fittings. Install the spring clamps securing the fuel hose and the fuel vent
hose.
Note: The fuel tank labels both vent and fuel ports and line orientation.
Chassis: Service and Repairs Page 5–70 TIMECUTTER® Service Manual
3433-938 Rev A