Stub Shaft Installation (continued)
g300753
Figure 65
3. Install the 4 (9/16 inch) nut and bolt (3 front, 1 back) securing the stub shaft
to the front axle asm. Hand tighten all fasteners.
g300752
Figure 66
4. Lower the machine to the floor. The weight of the machine should be on the
ground before tightening hardware.
5. Tighten the 2 bolts with nuts first, then tighten the self-tapping screws last
(rear before front). Torque bolts with nuts and screws to 36.5–44.5 N •
m (27–33 ft-lb).
6. Install the caster fork to the stub shaft. Secure with ½ inch bolt securing the
caster fork to the stub shaft. Torque the bolt to 36.5–44.5 N • m (27–33 ft-lb).
7. Install the dust cover.
TIMECUTTER® Service Manual
Page 5–21
Chassis: Service and Repairs
3433-938 Rev A
Summary of Contents for TIME CUTTER ZS 4200S
