Deck Lift Assembly 4 Point Removal (continued)
g301692
Figure 211
19. Remove the RH pod from the machine.
20. Remove the 2 (T-40) bolts securing the height-of-cut gate to chassis.
Remove the height-of-cut gate.
21. Remove the 8 (T-40) bolts securing the front and rear bellcranks to the
chassis. Remove the belle cranks.
Deck Lift Assembly 4 Point Installation
1. Install the bellecrank. Install the 8 (T-40) bolts securing the front and rear
bellcranks to the chassis. Torque bolts to 17–22.5 N • m (150–200 in-lb).
2. Install the height-of-cut gate. Install the 2 (T-40) bolts securing the
height-of-cut gate to chassis. Torque bolts to 17–22.5 N • m (150–200 in-lb).
3. Place the RH pod into position on the machine.
4. Install the control panel. Hand tighten with the screw securing the control
panel to the RH pod.
5. Install the smart speed knob to the smart speed lever. Hand tighten with the
screw securing the smart speed knob to the smart speed lever.
6. Move the motion control from the neutral position to the neutral lock position.
7. Install the 3 screws (per pod) securing the pod to the pod support brackets.
Torque screws to 11 N • m (100 in-lb).
8. Flip the seat back into position.
9. Install the center lift link. Install the 2 (9/16 inch) bolts and nuts securing
the center lift link to the front and rear bell cranks. Torque bolts and nuts to
40.5–44.5 N • m (30–33 ft-lb).
10. Install the deck to the machine.
11. Lower the deck lift into the lowest position.
Chassis: Service and Repairs
Page 5–98
TIMECUTTER® Service Manual
3433-938 Rev A
Summary of Contents for TIME CUTTER ZS 4200S
