Toro Polar Trac Cab 30474, Operator'S Manual

Page: 27 / 60

11
Removing the Summer
Frame
Parts needed for this procedure:
2 Roller assembly
1 Left bracket
1 Right bracket
2 Bolt (3/8 x 2-1/4 inches)
2 Bolt (3/8 x 5/8 inch)
4 Flange nut (3/8 inch)
2 Clevis pin
2 Self-tapping screw (1/4 inch)
2 Hose plugs
Installing the Conversion Rollers
1. Use a floor jack to lift the rear wheels off the
ground and support them with a jack stand.
2. On machines that have a serial number less
than 312999999, install the vertical tube support
assembly to each rear corner of the deck frame
with a clevis pin and a self-tapping screw (1/4
inch) (
Figure 47 ).
g024844
Figure 47
1. Deck frame 3. Clevis pin
2. Self-tapping screw (1/4
inch) 4. Roller assembly
3. On traction units that have a serial number
greater than 313000001, install a conversion
bracket (right or left hand) to the under-side of
the appropriate rear corner of the deck frame
with a self-tapping screw (3/8 x 5/8 inch) (
Figure
48 ).
Note:
Point the bracket toward the end of the
rear frame.
g024845
Figure 48
1. Deck frame 5. Self-tapping screw
2. Flange nut 6. Roller assembly
3. Conversion bracket 7. Self-tapping screw
4. Screw
4. Install the roller assembly to each conversion
bracket with a bolt (3/8 x 2-1/4 inches) and
flange nut (
Figure 48 ).
Removing the Operator Platform
1. Tilt the operator platform into its latched position
(
Figure 49 ).
g032441
Figure 49
1. Operator platform
27