Setup
Loose Parts
Use the chart below to verify that all parts have been shipped.
Procedure
Description
Qty.
Use
1
No parts required
–
Prepare the machine for installing the
kit.
Rear-panel shield
1
2
Under-seat shield
1
Install the heat shields.
Straight fitting (3/8 NPT x 0.625 barb)
1
Hose clamp (1/2 to 1-1/4 inches)
4
Hose clamp (3/4 to 1-1/2 inches)
1
Tee fitting
1
Female-dust fitting
1
3
Male-dust fitting
1
Assemble the heater hoses.
Grommet
1
Bulkhead bracket
1
Bolts (5/16 x 5/8 inch)
2
R-clamp
2
Carriage bolt (1/4 x 3/4 inch)
2
4
Flange nut (1/4 inch)
2
Install the bulkhead bracket.
Hose clamp (1/2 to 1-1/4 inches)
1
Straight fitting (3/8 npt x 0.625 barb)
1
Temperature sensor (Yanmar engine
only)
1
5
Adapter (Yanmar engine only)
1
Route the heater hose.
6
No parts required
–
Install the temperature sensor.
Washer bottle
1
Bracket
1
R-clamp
1
Carriage bolt (5/16 x 1 inch)
3
Bolt (5/16 x 3/4 inch)
2
Flange nut (5/16 inch)
5
Carriage bolt (1/4 x 3/4 inch)
1
7
Nut (1/4 inch)
1
Install the washer bottle.
Wire harness
1
Relay
1
Fuse (60 A)
1
Fuse (10 A)
2
Cable tie
3
Wire harness fuse block—Toro Part No.
92-2641 (purchased separately)
1
8
Key start harness—Toro Part No.
107-0672 (purchased separately)
1
Install the wire harness.
Skid plate
1
Bolt (3/8 x 1-1/4 inches)
2
Bolt (3/8 x 1 inch)
2
9
Flange nut (3/8 inch)
4
Install the skid plate.
7