Toro HydroJect 3010, Service Manual

Page: 75 / 124

Rev. B
Depths and Nozzle Configurations: All nozzles are identified with numbers indicating the drill size of the orifice. The
standard configuration is 11 nozzles producing depths of 4 to 6 inches depending on turf conditions. Blocked nozzle
locations are obtained by reversing the nozzle check valve ball and spring. See nozzle size chart and illustrations be-
low:
IMPORTANT: Use only nozzle configurations shown or damage to the machine may occur.
Part No. Approx.
Depth Drill Size Decimal Size
(inch)
Metric Size
(mm)
Quantity of Nozzles
Open
Blocked **
86–8130 #56 .0465 1.181 * * *
86–8131 #53 .0595 0 4–6”
86–8133 #46 .0810 2.057 6 5 6–8”
*
Use only with varied size configurations
NOZZLE SIZE AND APPROXIMATE DEPTH CHART
1.511 11
Aluminum Washer is required with any nozzle change:
Part no. 86–8150
Part No. Approx.
Depth Drill Size Decimal Size
(inch)
Metric Size
(mm)
Quantity of Nozzles
Open
Blocked **
86–8130 #56 .0465 1.181 6 and 0** 3–4”
86–8133 #46 .0810 2.057 5 0** 6–8”
OPTIONAL STAGGERED SIZE NOZZLE CONFIGURATION
Aluminum Washer is required with any nozzle change:
(S/N 29999 & Below) Part no. 80–6680
Part no. 86–8150
**Additional nozzles may be blocked to compensate for pump wear.
Hydroject 3010
Page 6 – 2.1
Specifications