Figure 67
1.
Left motion control lever
3.
Neutral locked position
2.
Right motion control lever
4.
Align the control levers
front to back
2. Rotate the thumb adjustments on either side. Adjust
them in quarter-turn increments until the right side
control lever moves easily into the neutral lock
position and the control levers align.
3. Check for proper tracking. Refer to Adjusting the
Tracking in the Maintenance Section.
Figure 68
1.
Left thumb adjustment
3.
Platform down
2.
Right thumb adjustment
Adjusting the Speed Control
Lever
1. Disengage the PTO, move the right side motion
control lever to the neutral position and set the
parking brake.
2. Stop the engine, remove the key, and wait for all
moving parts to stop before leaving the operating
position.
3. Move the HOC lever to the 1 inch height-of-cut
position (lowest position) (Figure 69).
4. Move the speed control lever to the fast position
(Figure 69).
5. Hold the motion control levers fully forward.
Figure 69
1.
Motion control levers fully
forward
3.
HOC lever in the 1 inch
height-of-cut position
(lowest position)
2.
Speed control lever in fast
position
6. Locate the cable and cable clamp under the frame in
front of the left wheel, as shown (Figure 70).
7. Loosen the cable clamp and pull the cable towards
rear of the unit until tight (Figure 70).
8. Tighten the cable clamp but not so tight that it
restricts the travel of the cable (Figure 70).
Figure 70
1.
Clamp
2.
Cable
46
Summary of Contents for GrandStand 74567TE
