G008959
1
2
Figure 11
1.
On
2.
Off
Operating the Ignition Switch
1. Turn the ignition key to the Start position
(Figure 12). When the engines starts, release the key.
Important:
Do not engage starter for more
than 5 seconds at a time. If the engine fails
to start allow a 15 second cool-down period
between attempts. Failure to follow these
instructions can burn out the starter motor.
Note:
Additional starting cycles may be required
when starting the engine for the first time after the
fuel system has been without fuel completely.
ST
ART
RUN
ST
OP
G008947
Figure 12
2. Turn the ignition key to stop to stop the engine.
Using the Speed Control
Lever
This machine has a speed control lever that sets the
speed of the machine. This can be adjusted to the
operator’s desired speed. It is recommended to use the
slowest speed for new operator’s.
1. Move the speed control lever to set the desired
speed.
2. Move the control levers to drive the machine. The
control levers may be pushed forward to the front
reference bar while the speed of the machine is
controlled by the speed control lever.
Figure 13
Using the Fuel Shut-Off Valve
Close the fuel shut-off valve for transport, maintenance,
and storage (Figure 14).
Ensure the fuel shut-off valve is open when starting
the engine.
16
Summary of Contents for GrandStand 74567TE
