Toro GrandStand 74567TE, Operator'S Manual

Page: 26 / 64

Maintenance
Note:
Determine the left and right sides of the machine from the normal operating position.
Recommended Maintenance Schedule(s)
Maintenance Service
Interval
Maintenance Procedure
After the first 8 hours
• Change the engine oil.
• Check the hydraulic fluid level.
• Change the hydraulic filter.
Before each use or daily
• Check the safety interlock system.
• Check the engine oil level.
• Clean the air intake screen.
• Check the brakes.
• Inspect the blades.
• Clean the mower deck.
Every 25 hours
• Clean foam air cleaner element.
Every 50 hours
• Check the paper air cleaner element.
• Check the tire pressure.
• Check the hydraulic fluid level.
Every 100 hours
• Change the engine oil. (more often in dirty or dusty conditions)
• Check, clean and regap the spark plug.
• Check the electric clutch.
• Check and clean engine cooling fins and shrouds.
• Check the mower deck belt.
• Check the pump drive belt.
• Check the hydraulic lines.
Every 200 hours
• Grease the mower deck spindles (more often in dirty or dusty conditions).
• Grease the lift linkage (more often in dirty or dusty conditions).
• Lubricate the traction rollers (more often in dirty or dusty conditions).
• Replace the paper air cleaner element.
• Change the engine oil filter.
Every 400 hours
• Replace the fuel filter.
• Check the battery electrolyte level.
• Change the hydraulic filter.
Every 500 hours
• Adjust the caster pivot bearing.
Every 800 hours
• Grease the front wheel bearings (more often in dirty or dusty conditions).
• Grease the front caster pivots (more often in dirty or dusty conditions).
Before storage
• Paint chipped surfaces.
• Perform all maintenance procedures listed above before storage.
Important:
Refer to your
Engine Operator’s Manual
for additional maintenance procedures.
If you leave the key in the ignition switch, someone could accidently start the engine and seriously
injure you or other bystanders.
Remove the key from the ignition and disconnect the spark plug wires from the spark plugs before you
do any maintenance. Set the wires aside so that they do not accidentally contact the spark plugs.
26